Separate names with a comma.
Discussion in 'Newbie Questions' started by lollyjay, Jan 20, 2019.
Both of my WiFi printers are showing "disabled" and I cannot figure out how to change to "enabled".
May be the the problem is with the printing service, it's called CUPS.
Try to install it :
sudo apt-get install cups
And check official doc about it.
If you want to enable the printer's wireless network card (or disable the printer's wireless network card, depending on the status).
first confirm the wireless function status of the printer:
The printer should be in Ready mode with the green Status light on steady.
Hold down the GO button until the printer starts printing, approximately 15 seconds.
Release the GO button when the printer prints a "Network Configuration page".
On the "Network Confirmation page" that prints, check the first line of information, called the "Node Type" line. Bluestacks Kodi Lucky Patcher
The word (Active) at the end of this line indicates the wireless function is ENABLED.
The printer is capable of receiving wireless communication.
The word (Inactive) at the end of this line indicates that the wireless function is DISABLED. The printer is NOT capable of receiving wireless communication in this mode.
Once you have determined the status of the wireless function on the printer, you can change the wireless function to Active or Inactive as needed for your printing needs.
Simply hold down the GO button again, for approximately 15 seconds, until another Network Configuration page starts printing. Depending on the previous status, this new page will show the word (Active) or (Inactive) at the end of the "Node Type" line.
exactly very good explicatin thanks for this helpful
Lucky Patcher 9Apps VidMate